ISO 9001 · ISO 14001 · NEBB Class 4–6 cleanrooms

Industry application

Wiping Cloths for Optics & Precision Instruments

On an optical surface, the cleaning cloth is a finishing tool. A scratch, a smear or a fiber is a defect that no downstream step can recover.

Material Rayon/polyester, fine microfiber, nonwoven microfiber Edge Cut edge for hand wipes; sealed edge for critical surfaces Class ISO Class 5–8 depending on the coating
Soft microfiber wipe beside an optical lens and precision display panel

Lens manufacturing, display assembly, fiber optics and precision instruments all share the same constraint: the surface is softer or more critical than the cloth. The wipe has to be softer than the coating and clean enough to leave no residue.

The right construction is usually a fine microfiber or a soft rayon/polyester, used with the approved solvent and a fresh face for each pass. A general-purpose cloth that works on a machine housing is the wrong tool on a coated lens.

01 Where the risk sits

Scratches and sleeks

A coarse fiber or a dry wipe on a coated surface leaves a scratch that polishing may not remove. Softness is a specification, not a preference.

Smear and residue

Too much solvent or a dirty cloth leaves a film that shows up in transmission or under a light. Use the validated solvent volume.

Particle redeposition

A loaded cloth moves particles around instead of removing them. Turn or replace the cloth before the surface is dry.

02 Specification

Material
Rayon/polyester, fine microfiber, nonwoven microfiber
Edge
Cut edge for hand wipes; sealed edge for critical surfaces
Cleanroom class
ISO Class 5–8 depending on the coating
Format
4 × 4 in, 9 × 9 in, small rolls

03 Recommended wipes

04 Cleaning protocol

01

Inspect first

Look at the surface under the specified light before cleaning. A scratch that is already there is not a cleaning defect.

02

Use the approved solvent

Apply the solvent to the cloth, not the lens. The cloth should be damp, not wet.

03

One pass, fresh face

Wipe slowly in one direction with a fresh face. Do not scrub or circle back over the same area.

04

Dry with a clean cloth

Finish with a dry, clean wipe if the SOP requires it. A wet surface attracts particles.

05

Pack immediately

Put the part into its clean carrier after inspection. A clean lens on an open bench does not stay clean.

05 Frequently asked questions

A soft rayon/polyester or fine microfiber wipe used damp with the approved solvent. Test on a scrap lens before production.

Start with a sample

Two wipes, one surface, a measurable difference.

Request an application sample
客服头像
Connecting...
Before we start, please tell us your name
Before we start, please tell us your name
Talk to us directly info@wipestar.com +86-755-8961-6773 Full contact form →
Support typing